How to Set Up Double Bass Pedal with Hi-Hat: A Step-by-Step Guide
Learn how to set up double bass pedal with hi-hat in clear steps: positioning, footboard angle, beater height, and hi-hat alignment for a smooth, even feel.
Updated November 2026
Setting up a double bass pedal with your hi-hat comes down to three things: placing both feet where they can work independently, matching the pedal angle to your leg, and making sure the hi-hat stays out of the way of your bass drum strokes. Once those are right, you can play bass drum patterns without your hi-hat foot drifting or fighting your kick. This guide walks through the process in the order most drummers find easiest.
Step 1: Position the Pedals and Throne
Start with your throne height. Most drummers sit with their knees slightly above their hips, and their feet resting naturally on the pedals without stretching. Set your bass drum so the pedal footboard sits roughly under the ball of your foot, not the heel.
Shopping for one? See our guide: 6 Best Electronic Drum Set Double Bass Pedals (2026): Our Picks.
Next, place the hi-hat stand to the left of your bass drum pedal, close enough that your left foot can rest on the hi-hat pedal without lifting your leg. A common starting point is about 4 to 6 inches between the footboards, though many players fine-tune this to their leg length. If your heels hit each other when you play, move the hi-hat stand slightly left.
Step 2: Set the Double Pedal Connection and Beater Angle
On a double pedal, the two beaters should strike the bass drum head at the same point. Adjust the linking rod or chain so the beaters sit about 1 to 2 inches from the batter head when at rest, then check that both strike near the center of the head.
- Set the footboard angle so your heel sits comfortably on the base plate.
- Adjust the beater height so the strike area is consistent with your sticking.
- Tighten the drive shaft and cam settings only after you confirm the feel.
Manufacturers often specify different cam and spring setups for different pedal designs, so follow your pedal’s instructions before making big changes.
Step 3: Align the Hi-Hat with Your Bass Drum Strokes
Play a slow quarter-note pattern on the hi-hat while alternating bass strokes. If your hi-hat foot needs to lift or reposition during kick patterns, the hi-hat is probably too far from the bass pedal or too high. Lower the hi-hat cup height or nudge the stand closer until both feet move freely.
Keep the hi-hat clutch and top cymbal tension consistent so the chick sound stays even while your left foot moves independently. Check that the hi-hat rod doesn’t contact the bass drum or pedal hardware.
Step 4: Test the Feel at Slow and Fast Tempos
Play a simple pattern at 80 BPM, then gradually increase to around 120 BPM. Listen for uneven double strokes, pedal rebound that feels too stiff or too loose, and any squeak or creep in the hi-hat. Make one adjustment at a time and retest so you know which change made the difference.
Common Mistakes and Tips
- Placing the hi-hat too far left, which forces your leg to overextend and slows your kick.
- Setting the throne too low, which makes your heel and knee angle cramp your bass strokes.
- Overtightening the spring tension, which causes fatigue and inconsistent rebound.
- Ignoring the beater strike point, which leads to uneven tone on double strokes.
- Forgetting to recheck the setup after moving the kit or changing heads.
Recommended Gear
A stable, adjustable hi-hat stand helps you keep the cymbal height and position fixed while you tune your foot spacing. Look for a stand with a sturdy base and independent height and tilt adjustments. View on Amazon
A practice pad with a bass drum pedal attachment lets you dial in your pedal angle without disturbing the full kit. View on Amazon
FAQ
Should the hi-hat pedal sit directly next to the bass pedal?
Usually not directly touching. Most drummers leave a few inches between the footboards so their heels don’t collide during fast patterns.
How high should the hi-hat cymbals be?
Set the top cymbal so you can close it with a comfortable downward motion of your left foot and without raising your leg. The exact height depends on your throne and leg length.
Does a double pedal change the hi-hat setup?
It can, because the double pedal occupies the same foot space. Test the hi-hat spacing after installing the double pedal, since the setup may need a small adjustment.
Conclusion
Once your throne, bass pedal, and hi-hat are aligned, you should be able to play kick and hi-hat patterns without your feet competing for space. Work through the steps in order and change one setting at a time. If you have a physical pain or posture concern, a drum instructor or physical therapist can help you adjust your setup safely.
Related reading
- Double Double Bass Pedal: How It Works and How to Set One Up
- Double Bass Pedal Longboard: How It Works and How to Set One Up
- Double Bass Pedal Drum Set: How to Choose and Set Up Your Kit
- DW Double Bass Pedal: How to Choose, Set Up and Tune Yours
Ready to choose one?
