How to Position Double Bass Pedal with Hi Hat: A Step-by-Step Guide
Learn how to position a double bass pedal with your hi hat so your feet stay relaxed, fast and accurate. Follow these steps for a comfortable, repeatable setup.
Updated November 2026
To position a double bass pedal with your hi hat, place the hi hat stand where your left foot rests naturally, set the bass pedals so their footboards line up with your heels, and keep your knees at a comfortable angle. Done right, you can move between hi hat and kick without twisting your hips or reaching. The steps below show how to find that spot and lock it in.
Start With Your Seating Position
Your throne sets the baseline for everything else. Sit with your back straight, your thighs roughly parallel to the floor or sloping slightly downward, and your feet resting on the pedals without stretching. If you have to lift your heel to reach the footboard, the throne is too low or too far from the kit.
Shopping for one? See our guide: 5 Best Electronic Drum Double Bass Pedal Options for Practice and Gigging (2026).
Once your seat height feels right, keep it fixed while you position the pedals. Changing the throne later will shift every measurement below.
Position the Hi Hat for Your Left Foot
The hi hat should sit close enough that your left foot can operate the clutch and pedal without leaving your seat. A common starting point is to place the hi hat stand so the cymbals are roughly at the height of your hip, angled slightly toward you. Test by lifting your left foot from the hi hat pedal and returning it; if your heel floats far off the board or your ankle bends sharply, move the stand.
- Sit at the kit and rest your left foot on the hi hat pedal.
- Press the pedal lightly and check that your knee stays relaxed, not locked.
- Adjust the hi hat’s leg spread and height until your foot lands in a neutral position.
Set the Double Bass Pedal Footboards and Angle
Your right foot handles the kick drum, and with a double pedal you want both beaters reachable from the same resting position. Place the bass pedals so the footboards sit about one foot-length in front of your heel, and align the rear pedal so it sits just behind the front one. Most drummers find that a slight outward angle of the pedal base, roughly 10 to 20 degrees, keeps the foot natural.
Next, check the beater-to-head distance. The beaters should land on the drum head without you extending your leg. Adjust the drum’s height or the pedal’s position so your foot’s natural arc brings the beater into contact.
Check the Spacing Between Hi Hat and Bass Pedals
Leave enough room between the hi hat pedal and the bass pedal footboards that your feet never collide. Many drummers keep a gap of about two to three inches at the closest point. If your feet bump during fills, move the hi hat stand outward or the bass pedal inward.
Lock In the Setup and Test It
Once everything feels comfortable, tighten all clamps and mark the positions if you tend to move your gear. Then play a simple pattern: closed hi hat on eighth notes with the kick on quarter notes, then double-kick patterns at a slow tempo. Watch for ankle strain, hip rotation or a heel that leaves the footboard. Any of these means a small adjustment is needed.
| Element | Target position |
|---|---|
| Thigh angle | Roughly parallel to floor or slightly downward |
| Hi hat pedal | Reachable by left foot without leaving the seat |
| Bass footboards | About one foot-length in front of heel |
| Foot gap | About 2 to 3 inches at closest point |
Common Mistakes
- Setting the hi hat too far from your body, causing you to lean or twist.
- Placing the bass footboards too close, which forces a cramped heel position.
- Ignoring throne height and adjusting only the pedals.
- Tightening clamps before testing the setup, then having to loosen everything again.
- Pushing through discomfort. Persistent ankle or knee pain warrants a visit to a doctor or physical therapist.
Recommended Gear
A stable hi hat stand keeps your carefully set height from drifting during play. Look for a stand with adjustable legs and a sturdy clutch. View on Amazon
A double pedal with independent footboard adjustments makes it easier to dial in the spacing for each foot. View on Amazon
FAQ
Should the bass pedals sit inside or outside the hi hat?
Most drummers place the bass pedals to the right of the hi hat, with the footboards on the same plane as the kick drum. Placement depends on your leg length and kit layout, so test both options if you are unsure. For a deeper comparison, see Double Bass Pedal Inside or Outside Hi Hat? Placement Guide.
How far should the hi hat be from my left knee?
The hi hat should be close enough that your left knee stays bent comfortably without your foot leaving the pedal. As a starting point, aim for a gap that lets you press the pedal with only a slight ankle movement. Adjust in small increments until the motion feels natural.
How often should I recheck my pedal and hi hat positions?
Recheck after moving your kit, changing throne height or swapping pedals, since each change affects alignment. Many drummers also review the setup every few weeks, because clamps and hardware can gradually loosen. For step-by-step setup help, see How to Set Up Double Bass Pedal with Hi-Hat: A Step-by-Step Guide.
Conclusion
Set your throne first, then position the hi hat for your left foot and the bass footboards for your right. Test the arrangement with simple patterns and make small changes until your feet move without strain. A stable, repeatable setup gives you more control and endurance, especially during long sessions and gigs.
Related reading
- How to Position Double Bass Pedal: Setup Steps for Comfortable Playing
- How to Set Up Double Bass Pedal: A Step-by-Step Guide for Beginners
Ready to choose one?
