Double Bass Pedal and Hi Hat Placement: A Step-by-Step Guide
Learn double bass pedal and hi hat placement step by step, with clear positioning tips that keep your feet relaxed and your timing tight. Read the guide.
Updated November 2026
Double bass pedal and hi hat placement comes down to one goal: letting both feet work without crowding each other or pulling your posture out of line. By the end of this guide, you will know how to position the hi-hat stand and the two bass pedals so each foot has a natural path, a comfortable angle and enough room to play fast passages without tension.
Start With Your Throne and Bass Drum Position
Placement begins with your seat, because everything else is measured from it. Sit with your knees slightly lower than your hips and your feet resting on the pedals without stretching. Most drummers find that a throne height where the thighs angle slightly downward gives the ankles the freedom to rock.
Shopping for one? See our guide: 5 Best Electronic Drum Double Bass Pedal Options for Practice and Gigging (2026).
Place the bass drum so the beater head lands roughly where your natural foot position falls, usually a few inches to the left of your left heel line if you are right-footed. Avoid reaching for the drum. If you have to lean forward or stretch, move the drum or the throne before touching the pedals.
Position the Hi-Hat for Your Left Hand and Left Foot
The hi-hat stand sits to the left of the kit for most right-handed drummers, and its foot pedal should line up with your left foot when it rests naturally. Set the cymbal so its edge sits at about the height of your left shoulder when your arm is relaxed. The hi-hat pedal should not be so far forward that your heel lifts off the floor, nor so far back that you have to twist your ankle.
Consider how the hi-hat and the double pedals share space. The hi-hat foot needs to stay clear of the bass drum rack and the second pedal’s footboard. If your left foot constantly bumps the hi-hat stand while you play bass, move the stand a half inch to an inch outward or angle its base.
Set the Double Pedal Angle and Spacing
The double pedal sits on the bass drum hoop, and the two footboards should be positioned so each foot can strike its beater without crossing over the other. A common starting point is to align the primary pedal’s footboard directly with your dominant foot and angle the secondary pedal slightly toward the outside.
Check the beater alignment. Each beater should strike the drumhead near its center. If one beater hits too high or too low, adjust the pedal’s clamp or the drum’s position until the strike zones match.
Checklist for Final Adjustments
- Sit at the throne and confirm your thighs angle slightly downward.
- Play a slow single stroke on each bass pedal and listen for even tone.
- Rock your left foot on the hi-hat without touching the bass pedals.
- Play a fast double stroke pattern and check that neither foot crowds the other.
- Tighten all clamps and recheck alignment after 10 minutes of playing.
Common Mistakes to Avoid
- Placing the hi-hat too far forward, which forces your heel off the floor.
- Setting the bass drum so far away that your leg fully extends on each stroke.
- Letting the hi-hat stand lean into the bass drum rack, causing rattles and foot collisions.
- Skipping the throne adjustment and trying to compensate with pedal tension alone.
- Ignoring slow practice after moving gear, which hides uneven strike points.
For a broader overview of configuration choices, see Double Bass Pedal Inside or Outside Hi Hat? Placement Guide and How to Set Up Double Bass Pedal with Hi-Hat: A Step-by-Step Guide. If you are still choosing between pedal styles, Single or Double Chain Bass Pedal (2026): Which Is Better for Your Drumming? explains how drive type affects feel.
Recommended Gear
- Double bass drum pedal: A dual-pedal unit with adjustable footboards and beater angles makes it easier to match each foot to its strike zone. View on Amazon
- Drum throne: A throne with a height range and a stable base lets you set the knee angle that placement depends on. View on Amazon
- Hi-hat stand: A stand with an adjustable footboard and clutch helps you place the hi-hat at the right height and distance from the bass drum. View on Amazon
FAQ
Should the hi-hat go inside or outside the double pedal?
Most drummers keep the hi-hat to the left of the bass drum, outside the pedal footprint, so the left foot can move freely. Placement inside the pedal zone is possible but usually cramps the left foot. Test both positions slowly before committing.
How far should the double pedal be from the hi-hat?
Leave enough space that your left heel can rest on the floor while the hi-hat foot rocks. A gap of a few inches between the hi-hat footboard and the bass pedal footboards is a practical starting range.
How often should I recheck my placement?
Recheck after moving the kit, changing thrones or switching pedals. Your ankles and legs may also adapt over weeks, so a quick reset every few months keeps the setup comfortable.
Conclusion
Good double bass pedal and hi hat placement starts at the throne and builds outward, with each foot given a clear, relaxed path. Make small changes, test them at slow tempos and then speed up. Once both feet feel natural, your focus can shift from setup to groove.
Related reading
Ready to choose one?
