We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Double Bass Drum Pedal Positioning: A Step-by-Step Guide for Drummers

Learn double bass drum pedal positioning step by step, from kick drum height and pedal angle to footboard alignment, so your feet work comfortably and fast.

Updated November 2026

Double bass drum pedal positioning comes down to one goal: letting your feet reach both kick drums with minimal movement, so your ankles and knees stay relaxed while you play. This guide walks through how to place each pedal, set the angle and align the footboards so your strokes feel even. By the end, you will have a setup you can repeat in a few minutes at any rehearsal space or gig.

Start With Your Throne and Kick Drum Height

Your throne sets the foundation for everything else. Sit with your thighs roughly parallel to the floor or sloping very slightly downward toward the knees, and keep your feet flat on the pedal boards. If your knees rise above your hips, lower the throne. If your heels lift off the floor when you play, raise it or move your pedals closer.

Shopping for one? See our guide: 5 Best Electronic Drum Double Bass Pedal Options for Practice and Gigging (2026).

Next, position the kick drums so your feet can reach them without stretching. Most drummers find that the batter head sits about an inch or two beyond the tip of their toes when their heel rests on the floor. Keep both kicks close enough that your legs stay in line with your hips, not splayed out to the sides.

Place Both Pedals and Set the Angle

Once your throne and kicks are set, mount the pedals. Position the footboard so the ball of your foot sits near its center, and the beater lines up with the middle of the drum head. Many drummers angle the pedal so the beater strikes the head at roughly a 90-degree angle, which produces the most consistent tone.

Set the pedal stance by keeping your heel on the floor and rotating your foot slightly outward. Your leading foot can sit at a slightly more forward angle, while the trailing foot follows the same line. Avoid crossing your legs or turning your knees inward, since this restricts your range of motion.

Align the Footboards and Chain Drives

The distance between the two footboards affects how comfortably you can alternate feet. Measure the gap between your heels while you sit in playing position, then adjust the pedals so the footboards sit roughly shoulder-width apart. A narrow gap can cause your feet to tangle, while a wide gap forces your hips to shift.

Check that the chain or direct-drive connections on each pedal run straight from the cam to the beater. If the chain sits at an odd angle, the beater may hit off-center or rebound unevenly. Tighten the clamps evenly so both kick drums respond with the same feel.

Quick Setup Checklist

  1. Set the throne so your thighs slope slightly downward.
  2. Position each kick drum within easy reach of your toes.
  3. Mount each pedal with the beater centered on the head.
  4. Adjust footboard spacing to roughly shoulder width.
  5. Play a slow pattern on each kick and listen for even tone and rebound.
  6. Recheck the setup after a few songs, since pedals can shift.

Common Mistakes

  • Placing the kicks too far apart, which forces your legs to splay.
  • Setting the throne too low, which weakens your strokes.
  • Letting the beater hit the head at an extreme angle.
  • Ignoring differences between your left and right foot placement.
  • Skipping a recheck, since hardware can loosen over time.

FAQ

Should both pedals be placed at the same height?

Usually yes, though your leading foot may sit slightly forward. Matching heights helps both kicks feel balanced under your feet.

How far apart should the two kick drums be?

Keep them close enough that your legs stay under your hips without stretching. Many drummers position the kicks side by side, touching or nearly touching.

Can I use the same setup for a single kick?

The core principles still apply, such as throne height and beater alignment. You can simply skip the second pedal and focus on one footboard.

Conclusion

Good double bass drum pedal positioning starts with your throne, then moves to kick placement, pedal angle and footboard spacing. Work through the checklist, play a few slow patterns, and make small adjustments until your feet feel relaxed. Revisit the setup whenever your kit or playing style changes.

Audrey Hayes

About Audrey Hayes

Audrey Hayes is part of our editorial team and reviews and edits our drums guides, checking product details against manufacturer specifications and owner feedback.

About the author

Audrey Hayes
Audrey Hayes

Audrey Hayes writes reviews and buying guides for Drum Path.